Ceramic lamp holder SK15

Thu, 09 Jul 2026 00:16:34 +0800

Introduction

Let’s get real. Glass annealing lines are energy monsters. And the heating stage? That’s where most of the electricity gets devoured. So we built the SK15 ceramic lamp holder to go straight after that cost. This isn’t just another heater. It’s a focused infrared emitter, built for the exact temperature curve annealing needs. It zeroes in on the lehr’s energy use and gives you a real, measurable cut in your yearly operating costs—without messing up your process control.

SK15 infrared lamp for glass

Fri, 03 Jul 2026 14:35:10 +0800

Out on the glass line, heat is more than just temperature. It’s timing, stability, and repeatability—every single shift. When your heating module starts to drift, you pay for it in uneven tempering, sluggish lamination cycles, and insulating units that end up in the scrap bin. The SK15 infrared lamp is built to keep that thermal profile honest, shift after shift. What makes it tick The SK15 runs on short-wave infrared (NIR) inside a compact quartz envelope. That gives you fast response and tight control. In practice, you get quick ramp-up when you’re pushing high throughput on bending and tempering, and a stable hold when you’re running EVA/SGP/PVB lamination. The output is tuned for glass emissivity, so the energy goes straight into the glass, not the air around it. You end up with repeatable uniformity across the heated zone, which cuts down on thermal stress and edge defects. Here is why it holds up in real work. On the tempering and bending side, the SK15 shortens heat-up time and locks in the soak window. That helps you hit your bend radius and surface compression targets without chasing the furnace curve. In lamination, it brings the interlayer to the right flow point fast, trimming cycle time while keeping bubbles and haze in check. For insulating glass sealing and coating drying, the focused heat reduces convection interference, so you get even cure without overheating adjacent surfaces. It also runs efficiently at industrial duty cycles. Field-level details you need Installation is a straight drop-in for most glass processing machines, with mounting and wiring options that match common OEM footprints. We include an adapter kit so you can swap the lamp without cutting up the machine frame. Keep the lamp window clean—dust and condensation will cost you performance. Use clean, dry air for cooling and double-check reflector alignment. Match voltage and connector specs to your line, and confirm the reflector geometry matches your beam profile before you sign off.

SK15 on Glass Infrared Heating Systems

Ceramic lamp holder SK15

Introduction

SK15 infrared lamp for glass